6.5.4. Upgrading Firmware By Way Of Memory Card V2.6.6 Earlier
A strong ATevo charger function is that the main Management Board (A1) firmware (or software program) can be easily up to date in the sector with out uninstalling the charger or any boards. The process takes minutes. These can be up to date independently or at the identical time. Next, copy these files onto an SD Memory Card, using both a private computer (Laptop) with an SD Memory Card slot, or a USB to SD Memory Card adapter. When the recordsdata are on the SD Memory Card switch them to ATevo. Open the ATevo entrance panel door, and Memory Wave App find the SD Memory Card socket on the back of the primary Management Board (A1). Immediately beneath the socket will probably be a ‘RE-FLASH Allow JUMPER’. Move shorting block on jumper to ‘PRGM’ position. Insert ATevo-compatible SD Memory Card with program information into socket. Press RESET button (SW13) situated 3in / 76mm beneath RE-FLASH JUMPER. If mainapp.bin is stored on the card, the message below will appear. Choose ‘Yes’ if desired.
A message will affirm that the primary Software program has updated. If the SD Memory Card incorporates the bruno.bin file, Memory Wave you'll be prompted to upgrade the Show Utility program. Choose ‘Yes’ if desired, Memory Wave App and a message will confirm the replace. The charger will reset and immediate you to improve the principle Utility program again. Transfer the RE-FLASH JUMPER shorting block back to the ‘NORM’, regular operating place and press RESET. The ATevo will re-boot. When it restarts, Memory Wave App it will be operating the brand Memory Wave new put in program(s). For the reason that introduction of firmware v2.7.0 with ATevo items that started being sold in 2021, modifications to the method and Memory Wave App the format of information used for upgrading firmware have been made - as detailed in the following subject. If your ATevo was originally equipped with firmware v2.6.6 or earlier, these adjustments will largely not affect you. However, some customers have asked the following questions.
A: Yes. Contact the producer. Q: Can an ATevo working firmware prior to v2.7.0 use the single file with the brand new file format? A: No. If your ATevo runs firmware previous to v2.7.0, contact the producer and request the two outdated-format firmware improve information, then comply with the directions above. Q: What if new and previous format firmware recordsdata are on a Memory Wave App card used to update an ATevo? A: If the card is in an ATevo running v2.6.6 and prior, it'll only recognize the older file sorts. An ATevo operating 2.7.Zero and later will first search for the newer file sorts (.HPB extension) and show a list to select from. The replace will be performed utilizing one of those recordsdata If the person selects one. The older information can be ignored on this case. If the user presses ESC somewhat than choosing considered one of the new file varieties it would then test for the older file varieties.
